San Diego side · Mobile motorcycle locksmith · We come to your bike · Open every day, 8am to 9pm · Switch to Ventura County and Santa Barbara · Español
(619) 775-1858

BMW G 650 Xcountry, Xchallenge, Xmoto Key Replacement

The three G 650 X singles are the simple ones in BMW's lineup.

  • Motorcycles and scooters only
  • We come to your bike
  • Keys cut and programmed on site
  • Proof of ownership required
Quick answerThe three G 650 X singles are the simple ones in BMW's lineup. Their US rider's manuals list one master key and one spare key, say the same key works the ignition and steering lock, the tank filler cap and the seat lock, and have no electronic immobilizer chapter. Replacing a lost key is a matter of cutting metal, with no dealer coding.

BMW G 650 Xcountry, Xchallenge, Xmoto key quick facts

  • BMW's US rider's manuals for the G 650 Xcountry, Xchallenge and Xmoto each say you receive one master key and one spare key.
  • All three manuals state that the ignition and steering lock, tank filler cap lock and seat lock are operated with the same key.
  • The seat comes off by turning the seat lock counterclockwise with the ignition key and holding it while you lift the rear of the seat.
  • The fuel tank cap is opened by turning the ignition key counterclockwise and closed by turning it clockwise.
  • None of the G 650 X manuals from 2006 to 2008 has an EWS section, although BMW's bigger bikes of the same years did.

BMW G 650 Xcountry, Xchallenge, Xmoto key types by year

YearsModelsKey typeChipNotes
About 2007-2009G 650 Xcountrymechanical cut keynoOne master key and one spare key per the US manuals dated July 2007 and March 2008.
About 2007-2008G 650 Xchallenge, G 650 Xmotomechanical cut keynoSame key set and the same three locks as the Xcountry, per the July 2007 US manuals.

Three bikes, one lock layout

The scrambler-style Xcountry, the long-travel Xchallenge and the supermoto Xmoto share a frame, an engine and a set of locks. In each rider's manual the keys take up a few lines under the heading for the ignition switch and steering lock. The switch has three positions: one for ignition on, one for off with the bars free, and one that locks the handlebars once you have turned them to the left. The key comes out in the two off positions.

What you will not find is the EWS chapter printed in the manuals for the R 1200 GS or F 800 of the same period. Nothing in a G 650 X manual describes a key being recognized, and the warning light list has no key or EWS warning.

Need a key for your G 650 Xcountry?

Call or text with the year and where the bike is parked.

Seat, tank cap and what sits under the seat

On these bikes the fuel tank is under the seat area and the filler is toward the rear on the right side, near the seat lock. That puts two of the three locks close together and low enough to collect dirt on a bike that is ridden off pavement.

The seat lock matters more than it looks. The manuals show the onboard toolkit, the rider's manual, the fuse box and the engine oil filler under the seat, and on the Xchallenge the air pump for its air damping system is there too. A seat lock that will not turn keeps you from all of it.

  • Ignition switch and steering lock: one key, handlebars lock to the left
  • Tank filler cap: counterclockwise to open, clockwise to close
  • Seat lock: counterclockwise and hold, then raise the seat at the rear

Dirt, dust and a short key supply

A G 650 X left the factory with only two keys, so a used one may be down to one. Trail dust and pressure washing are hard on a seat lock and a tank cap, and a key that has been bent in a boot or a pocket is a key to replace.

If your one key is starting to stick, have a fresh one cut before it breaks. A key made to the original cut works better than a copy of a worn one, and it gives you something to fall back on.

No keys at all: what we do

We ask for photo ID and the registration or title first. Then the key is made from the bike's own locks, cut on site and tried in the ignition, the steering lock position, the tank cap and the seat. Because the key carries no chip, there is no programming step and nothing to order by VIN.

If the ignition switch was damaged in a theft attempt, say so when you call. That changes the visit from a key job to a lock repair, and we will plan for it.

Where to find the key code

The G 650 X rider's manuals list the keys supplied but do not describe a key number tag, so do not count on finding a code in the paperwork. A key is normally made from the locks on the bike. If a previous owner kept a number with the documents, pass it along.

What to have ready

Have this ready when you call or text

  • Year, make and model of the bike
  • Where the bike is parked
  • Whether you have any working key, a broken key or a key code
  • Photo ID and registration or title (we verify ownership before making a key)

BMW G 650 Xcountry, Xchallenge, Xmoto key FAQ

Does a G 650 Xchallenge need a programmed key?

No. BMW's rider's manual for the Xchallenge describes one master key and one spare key and has no immobilizer section. A correctly cut key starts the bike.

Do the Xcountry, Xchallenge and Xmoto all use the same kind of key?

Yes. Their manuals use the same wording: one master key, one spare key, and one key for the ignition and steering lock, the tank filler cap lock and the seat lock. Each bike is still cut to its own pattern.

My fuse box is under the seat and the seat lock is jammed. Can you help?

Yes. Opening a stuck seat lock without damage and then cleaning or repairing it is routine work. It is worth doing promptly on a G 650 X because the toolkit and fuses are under there.

Is the G 650 X key the same as the G 650 GS key?

They are different motorcycles with their own locks, and each bike's key is cut to that bike. We have a separate page for the F 650 GS single and G 650 GS.

More BMW models

Services for this bike

Where we come to you

Sources

Page last updated .

Call nowText us